Fuel/Water Level Senders

Suitable for Gas, Diesel and Water

SFW sender

Instructions on the Fuel/Water Sender

View and Download the Fuel/Water Sender Flyer

How It Works

Measurement is done by series of reed switches positioned inside the level tube. A float with built in magnets then triggers the reed relays generating a potential - free resistance with an ohm value that increases or decreases.

The float is the only moving part of the sensor, thereby minimizing potential mechanical failures. All sensors are fully insulated to protect against voltage inside the tank.

  • Suitable for Gas, Diesel and Water
  • 316 Stainless Steel
  • SAE 5 Hole Pattern
  • 240-33 OHMS
  • Other resistances available upon request
  • Constructed to meet and/or exceed all applicable ISO standards
  • Optional threaded NPT Adapter for screw in applications
  • Sensors are fully insulated to protect against voltage inside the tank
  • Float is the only moving part of the sensor, minimizing mechanical failure
Sender Length

Sending unit length should be a minimum of one (1) inch less than the plastic tank depth, and three quarters (0.75) of an inch less than the metal tank depth. Note: If metal tank surface flexes, deduct one (1) inch from the depth.

chart

Fuel Level Gauges

Mega & Race Series Stock Gauges
Mega & Race Series Stock fuel gauge

Available in two sizes: 2 1/16" or 2 5/8" cutout

Two ohms resistances: 240-33 ohms or 0-90 ohms

For more info click here.

2 1/16" cutout

Two ohms resistances: 240-33 ohms or 0-90 ohms

For more info click here.


Water Level Gauges

Mega & Race Series

For Mega & Race Series click here.

For Stock Water Levelclick here.

Available in two sizes: 2 1/16" or 2 5/8" cutout

back to Main Sender page
top
The #1 Choice in Performance!