4″ gauge to 3 3/8″ gauge adapter bezel – FLGPS
$38.26
This gauge bezel is a great solution when upgrading your dash to Livorsi gauges, but your boat has a 4″ hole for a speedometer and tachometer. This bezel has an inside diameter of 3 3/8″ to center your Livorsi gauge, a machined lip that is 3.74″ to center your new gauge in the larger hole, and an outside diameter of 4.48. It is machined from 6061 aluminum and available in all 12 Livorsi standard colors.
Tech Help
Related products
-
$14.20
Four piece diode kit for Livorsi throttles – DK
Add to CartDiodes only, 4-piece kit. A diode is a electronic component that acts like a one-way check valve, Allowing current to flow easily in one direction while blocking it in the opposite direction. This is commonly used when using one control …
-
$362.63
18″ stroke actuator – ACB-18
Add to Cart25.75″ in the closed position, center to center, and 43.75″ in the open position, center to center. When running at 12 volts DC, these actuators have a push and pull force of 450 lbs.
-
$26.64
Harness for Livorsi 24 volt analog gauges – DCH24
Add to CartThese factory-assembled harnesses plug into all Livorsi analog gauges. Populated in all 4 of the DT06-4S sockets are the following 24″ long wires:
GREEN WIRE – SIGNAL
BLUE WIRE – LIGHTING
BLACK WIRE – GROUND
VIOLET WIRE – 12V POWER…
-
$159.89
23′ electric throttle and shift harness for Indmar engines – CHEECIND23
Add to CartThis 23″ long harness is a plug-and-play solution for any Livorsi EEC side-mount throttle and an Indmar marine engine with a Velvet Drive transmission.