NMEA 2000® male terminator – 010-11080-00
$13.73
This standard male NMEA 2000 light cable connector provides termination resistance for one end of the backbone of the network. Each male or female connector sold separately.
Part Number: 010-11080-00
You will also need:
-
$13.73
NMEA 2000® male terminator – 010-11080-00
Add to CartThis standard male NMEA 2000 light cable connector provides termination resistance for one end of the backbone of the network. Each male or female connector sold separately.
-
$13.73
NMEA 2000® female terminator – 010-11081-00
Add to CartThis standard female NMEA 2000 light cable connector provides termination resistance for one end of the backbone of the network. Each male or female connector sold separately.
-
$28.85
T for NMEA 2000 backbone – 010-11078-00
Add to CartAdd components to your NMEA 2000 network by installing our T-connector on your backbone cable. The revised version of this T-connector is offset by 45 degrees compared to the previous version.
Related products
-
$25.98
LinkUp LED indicator interface harness for single device – GATEWAYVHARNESS1
Add to CartThis harness is made for setups where you’re using a LinkUp NMEA 2000® gateway with a single-slot Livorsi Marine adjustable LED indicator. Since the LinkUp gateway is programmed using your smartphone, it’s often easier to install it near the dash instead …
-
$32.39
LinkUp LED indicator interface harness for twin device – GATEWAYVHARNESS2
Add to CartThis harness is specifically for applications when the Link Up NMEA 2000 gateway is used with a two-slot Livorsi Marine adjustable LED indicator. Since the Link Up gateway requires programming via your smartphone, it could be more convenient to mount the …
-
$198.81
LinkUp NMEA 2000 gateway – GATEWAYV
Add to CartThe LinkUp Gateway makes it easy to connect things like fuel level sensors, trim tabs, rudder angles, and engine data to your boat’s NMEA 2000® system. If you’re adding new electronics or upgrading old wiring, this device helps turn those …
-
$60.07
N2K only LED indicator main harness – LED2HNM30
Add to CartThis harness is required for all Livorsi Adjustable LED Position Indicators using NMEA 2000 exclusively for both input and output. One end connects directly to your NMEA 2000 backbone, while the other features a 12-pin Deutsch connector that interfaces seamlessly with your …